Canyon 2WD L5-3.5L VIN 6 (2004)
Catalyst Shield: Service and Repair
Catalytic Converter Heat Shield Replacement
Removal Procedure
Caution: Refer to Exhaust Service Caution in Service Precautions.
Caution: Refer to Protective Goggles and Glove Caution in Service Precautions.
1. Raise and support the vehicle.
2. Remove the 5 nuts securing the heat shield to the floor panel.
3. Remove the catalytic converter heat shield from the floor panel.
Installation Procedure
1. Position the catalytic converter heat shield to the floor panel studs.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the 5 nuts securing the heat shield to the floor panel.
^
Tighten the heat shield nuts to 9 Nm (80 inch lbs.).
3. Lower the vehicle.
