Canyon 2WD L5-3.5L VIN 6 (2004)
Note
To avoid damaging the sheet metal behind the trim panel, the drill bit must NOT extend more than 12 mm (3/16 in) from the outside edge of the
hole saw.
5. Using a 63.5 mm (2.5 in) hole saw, cut a hole in the panel to gain access to the center tether access anchor point. Use the marks made in Steps 5
and 6 as your center point for the cut.
6. Clean the edge of the hole with a file. The actual hole will appear slightly larger than shown in the illustration.
7. Clean the debris from the floor using a vacuum cleaner.
8. Reinstall the tether access cover over the passenger side tether access point.