Canyon 2WD L5-3.5L VIN 6 (2004)
7. Remove the bolt that retains the seat belt retractor/pretensioner assembly to the body.
8. Remove the front seat belt assembly from the vehicle.
INSTALLATION PROCEDURE
1. Position the rear seat belt retractor/pretensioner assembly to the vehicle.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the bolt which retains the seat belt retractor/pretensioner assembly to the body.
Tighten
Tighten the seat belt retractor/pretensioner bolt to 52.5 N.m (39 lb ft).
3. Connect the electrical connector to the retractor/pretensioner.
4. Install the front seat belt upper guide with the bolt. Ensure that the seat belt webbing is not twisted.
Tighten
Tighten the front seat belt upper guide bolt to 52.5 N.m (39 lb ft).
5. Install the front seat belt upper guide shoulder bolt trim cover.
6. Install the body rear corner trim panel.
7. Install the front seat belt anchor bolt. Ensure that the seat belt webbing is not twisted.
Tighten
Tighten the front seat belt anchor bolt to 52.5 N.m (39 lb ft).
8. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 2 and SIR Disabling and Enabling Zone 6 in Restraint Systems.