Canyon 2WD L5-3.5L VIN 6 (2004)
7.
Loose install the steering gear vertical mounting nuts, the washers and the bolts.
Tighten
^
Tighten the long bolts to 130 N.m (96 lb-ft).
^
Tighten the isolator clamp bolts to 100 N.m (74 lb-ft).
8.
Install the intermediate shaft to the steering gear.
9.
Install the coupler clamp bolt to the intermediate shaft. Refer to Intermediate Steering Shaft Replacement - Lower in Steering Wheel and Column.
10.
Connect the power steering hose assembly to the steering gear. Refer to Power Steering Gear Inlet and Outlet Hose Replacement.
11.
Install the engine protection shield, if equipped. Refer to Engine Protection Shield Replacement in Frame and Underbody.
12.
Install the outer tie rod end to the steering knuckle. Refer to Rack and Pinion Outer Tie Rod End Replacement.
13.
Install both of the front tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
14.
Lower the vehicle.
15.
Bleed the power steering system. Refer to Bleeding the Power Steering System.
16.
Check the wheel alignment. Refer to Measuring Wheel Alignment in Wheel Alignment.
Power Steering Gear Replacement (H3)
Removal Procedure
1.
Raise and support the vehicle.
2.
Remove both of the front tire and wheel assemblies.
3.
Remove the engine shield.