Canyon 2WD L5-3.5L VIN 6 (2004)
1.
Install the steering gear into the vehicle.
2.
Install the steering gear RH isolator bracket.
3.
Loose install the steering gear horizontal mounting nuts, the washers and the bolts.
Note:
Refer to Fastener Notice.
4.
Loose install the steering gear vertical mounting nuts, the washers and the bolts.
Tighten
^
Tighten the long bolts to 130 N.m (96 lb-ft).
^
Tighten the isolator clamp bolts to 100 N.m (74 lb-ft).
5.
Install the intermediate shaft to the steering gear.
6.
Install the coupler clamp bolt to the intermediate shaft. Refer to Intermediate Steering Shaft Replacement - Lower.