Canyon 4WD L5-3.7L (2007)
9. Measure the rotating torque of the pinion. Compare this measurement with the rotating torque recorded during removal.
Tighten the nut in small increments, as needed, until the rotating torque is 0.40-0.57 N.m (3-5 lb in) greater than the rotating torque
recorded during removal.
10. Once the specified torque is obtained, rotate the pinion several times to ensure the bearings have seated. Recheck the rotating torque and adjust if
necessary.
11. Install the propeller shaft.
-
For vehicles equipped with one piece propeller shafts, refer to Propeller Shaft Replacement - One Piece.
-
For vehicles equipped with two piece propeller shafts, refer to Propeller Shaft Replacement - Two Piece.