Canyon 4WD L5-3.7L (2007)
3. Place the control lever gasket on to the transmission.
4. Position the control lever housing assembly to the control lever assembly opening, aligning the bushing with the internal shift control lever.
Notice: Refer to Fastener Notice.
5. Install the control lever housing assembly bolts.
Tighten the control lever assembly bolts to 20 N.m (15 lb ft).
6. Slide the boot into position over the control lever.
Important: Ensure the carpet is not between the boot and the floor panel.
7. Tilt the boot in order to seat to the floor.
8. Install the control lever boot screws.
Tighten the control lever boot screws to 2.5 N.m (22 lb in).
9. Install the console (w/o D06 only). Refer to Console Replacement (Small W/ Manual Transmission).
10. Install the shift lever assembly. Refer to Shift Lever Assembly Replacement (D06) Shift Lever Assembly Replacement (W/O D06).