Envoy 2WD L6-4.2L (2008)
Tighten the nuts to 32 N.m (24 lb ft).
Steering Gear Inner Tie Rod Replacement - Off Vehicle (Magnasteer)
Steering Gear Inner Tie Rod Replacement - Off Vehicle (Magnasteer)
Tools Required
J 34028 Inner Tie Rod Wrench
Disassembly Procedure
1. To remove the rack and pinion boot. Refer to Steering Gear Boot Replacement - Off Vehicle (See: ) .
2. Place the gear in a vise.
Notice: Do not change the steering gear preload adjustment before moving the inner tie rod from the steering gear. Changing the steering gear
preload adjustment before moving the inner tie rod could result in damage to the pinion and the steering gear.
3. Remove the shock dampener (6) from the inner tie rod housing (4).
4. Slide the shock dampener (6) back on the rack (5).
Notice: The pipe wrench must be placed at the valve end of the steering gear and positioned up against the inner tie rod housing. Placing the pipe
wrench in any other location will cause damage to the steering gear.
5. Place a pipe wrench on the rack (5) next to the inner tie rod housing (4).
6. Place a wrench on the flats of the inner tie rod housing (4).
7. Rotate the inner tie rod housing (4) counterclockwise, while holding the rack stationary, until the inner tie rod separates from the rack (5).
8. Remove the shock dampener (3) from the inner tie rod housing (2).
9. Slide the shock dampener (3) back on the rack (5).
Notice: Refer to Pipe Wrench Positioning Notice .
10. Place a pipe wrench on the rack.
11. Place a wrench on the flats of the inner tie rod housing (2).
12. Rotate the inner tie rod housing (2) counterclockwise, while holding the rack stationary, until the inner tie rod (1) separates from the rack (5).