Envoy 2WD L6-4.2L (2008)
Control Arm: Service and Repair
Front Suspension
Upper Control Arm Replacement
Upper Control Arm Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and Repair) .
3. Remove and discard the upper ball joint to upper control arm bolt and nut.
4. Separate the upper control arm from the steering knuckle.
5. Remove the wheel speed sensor wiring harness from the upper control arm. Refer to Wheel Speed Sensor Replacement .
6. If servicing the left upper control arm, remove the battery tray. Refer to Battery Tray Replacement .
7. Gently pry out on inner fender body panel to access forward facing bolt.
8. Remove the upper control arm mounting bolts.
9. Remove the upper control arm.