Envoy 2WD L6-4.2L (2008)
Stabilizer Bushing: Service and Repair
Rear Suspension
Stabilizer Shaft Insulator Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the stabilizer shaft insulator clamp mounting nut.
3. Remove the stabilizer shaft insulator clamp.
4. Remove the stabilizer shaft insulator from the stabilizer shaft.
Installation Procedure
1. Install the stabilizer shaft insulator to the stabilizer shaft.
2. Install the stabilizer shaft insulator clamp.
Notice: Refer to Fastener Notice .
3. Install the stabilizer shaft insulator clamp mounting nut.
Tighten the stabilizer shaft insulator clamp mounting nut to 75 N.m (55 lb ft).
4. Lower the vehicle.