Envoy 2WD V8-5.3L (2007)
Clutch Control Solenoid Valve: Service and Repair
Control and Shift Solenoids Replacement
Removal Procedure
1. Remove the transmission oil pan and filter. Refer to Automatic Transmission Fluid and Filter Replacement.
Important: Do not remove the valve body for the following procedures. Removal of the 1-2 accumulator is necessary only if servicing the
pressure control solenoid.
2. Remove the 1-2 accumulator if necessary. Refer to Accumulator Assembly, Spacer Plate, and Gaskets.
3. Disconnect the internal wiring harness electrical connectors from the following components:
^
Transmission fluid pressure switch (1)
^
1-2 shift control solenoid (2)
^
2-3 shift control solenoid (3)
^
Pressure control solenoid (4)
^
Torque converter clutch (TCC) pulse width modulation (PWM) solenoid (5)
^
3-2 control solenoid (6)
4. Remove the pressure control solenoid retainer.
5. Remove the pressure control solenoid.
6. Remove the 1-2 and 2-3 shift solenoid retainers.
7. Remove the 1-2 and 2-3 shift solenoids.