Envoy 2WD V8-5.3L (2007)
INSTALLATION PROCEDURE
1. Clean the top edge of the windshield surface with a 50/50 mixture of isopropyl alcohol and water by volume on a dampened lint - free cloth.
2. The new reveal molding should be fitted to the windshield prior to installation.
3. CAUTION: Refer to Window Retention Caution.
Verify all primers and urethane adhesive are within expiration dates.
4. IMPORTANT: Use care when applying the prep (clear #1) to the windshield. This primer dries almost instantly, and may stain the viewing area
of the windshield if not applied evenly.
Use a new dauber in order to apply glass prep (clear #1) to the channel area approximately 13 mm (1/2 in) to the upper edge of the windshield.
5. Wipe the glass primed area immediately with a clean lint-free cloth.
6. Shake the glass primer (black #2) for at least one minute. Using a new dauber in order to apply glass primer (black #2) to the top edge of the
windshield.
7. Apply a small bead of urethane adhesive (2) between the windshield (1) and the pinchweld.
8. Install the upper reveal molding.
1. Start from the center and hand-press the reveal molding into place over the edge of the windshield.
2. Install both right and left sides of the reveal molding.
3. Run warm water over the reveal molding in order to speed the setup time of the urethane adhesive.Tape should be applied in order to retain the
reveal molding to the windshield, this will maintain a flush fit with the body.The tape is to be removed after 6 hours.
Windshield Reveal Molding Replacement
WINDSHIELD REVEAL MOLDING REPLACEMENT
The windshield reveal molding is an applied molding design separate from the window. The reveal molding is bonded to the windshield and may be
bonded to the body. The reveal molding may be replaced with the windshield as an assembly, or the reveal molding may be available as a separate
service part. Refer to Urethane Adhesive Installation of Stationary Windows.
