Envoy 2WD V8-5.3L VIN M (2005)
2. Install the outside handle lock rods to the latch as previously noted.
3. Install the inside handle lock rods to the latch as previously noted.
4. Position the latch in order to connect the electrical connectors as needed.
5. Install the latch to the door.
Notice: Refer to Fastener Notice in Service Precautions.
6. Install the 3 screws that retain the latch to the door.
Tighten the screws to 10 N.m (22 lb in).
7. Install the inside door handle.
8. Connect the lock cylinder rod to the cylinder, if equipped.
9. Install the lock rod to the outside door handle.
10. Connect the lock rod retaining clip to the outside door handle.
11. Install the water deflector.
12. Install the door trim panel.