Envoy 2WD V8-5.3L VIN M (2005)
1. Install the license plate pocket to the endgate.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the nuts retaining the license plate pocket to the endgate.
Tighten the license plate pocket nuts to 10 N.m (89 lb in).
3. Connect the main license plate pocket electrical connector (1).
4. Connect the electrical connector to the swing function handle (2).
5. Install the license plate pocket wiring harness retainers to the endgate.
6. Install the lock cylinder.
7. Install the inner reinforcement.
8. Install the endgate trim panel.