Envoy 2WD V8-5.3L VIN M (2005)
1. Remove the cargo shelf.
2. Tumble the third row seats to the cargo position.
3. Remove the right body side window rear garnish molding.
4. Remove the right body side window forward garnish molding.
5. Remove the liftgate sill plate.
6. Remove the right rear door sill panel.
7. Remove the lower seat belt anchor bolt.
8. Release the five screws that retain the rear quarter trim panel to the body.
9. Remove the rear quarter trim panel from the vehicle.
Installation Procedure
1. Position the trim panel to the vehicle.
2. Position the seat belt over the top of the trim panel, ensuring that the buckle is not behind the trim panel.
3. Index the locating tabs on the trim panel to the holes in the body.
4. Connect the wiring harness connector to the auxiliary power outlet.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the five screws that the retain the rear quarter trim panel to the body.
Tighten the rear quarter trim panel screws to 2.5 N.m (22 lb in).
6. Install the seat belt lower anchor.
Tighten the seat belt anchor bolt to 70 N.m (52 lb ft).
7. Install the right rear door sill panel.
8. Install the liftgate sill plate.
9. Install the right body side window forward garnish molding.
10. Install the right body side window rear garnish molding.
11. Return the third row seats to the upright position.
12. Install the cargo shelf.
Trim Panel Replacement - Rear Quarter - Right (TrailBlazer, Envoy, Bravada)