Envoy 2WD V8-5.3L VIN M (2005)
7. Install the 2 hog rings (1) to the bottom rear side of the cover and pad.
8. Press the seat cover hook and loop retaining strips together by running your hand firmly over the seat cover.
9. Connect the seat cushion heater electrical connector.
10. Install the seat electrical harness to the seat pan.
11. Install the SIR electrical harness (2) to the seat pan.
12. Install the front/rear J strips (2,4).
13. Install the side J strips (1,3).
14. Install the seat pan to the seat adjuster frame.
15. Install the 4 retaining nuts to the studs on the underside of the cushion.
Tighten the nuts to 25 N.m (18 lb ft).
16. Install the 3 seat switch bezel screws.
Seat Cushion Pull Strap Replacement - Rear No. 1 (TrailBlazer, Envoy, Rainier)
Seat Cushion Pull Strap Replacement - Rear No. 1 (TrailBlazer, Envoy, Rainier)
Removal Procedure
1. Remove the rear seat cushion assembly from the vehicle.
