Envoy 2WD V8-5.3L VIN M (2005)
2. Disconnect the electrical connector from the mode actuator.
3. Remove the screws from the mode actuator (3).
4. Remove the mode actuator.
INSTALLATION PROCEDURE
1. Install the mode actuator (3).
IMPORTANT: The new actuator is in Bi-Level mode. Place the door in the middle of the travel position before you install the actuator.
2. Install the screws to the mode actuator (3).
Tighten the screws to 1.9 N.m (18 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the left side sound insulator screws.
Mode Actuator - Auxiliary
MODE ACTUATOR REPLACEMENT - AUXILIARY
REMOVAL PROCEDURE
1. Remove the right rear quarter trim panel.
2. Disconnect the electrical connector from the mode actuator-auxiliary (1).
3. Remove the mode actuator-auxiliary (1) from the HVAC module-auxiliary.
4. Remove the retaining screws from the mode actuator-auxiliary.
INSTALLATION PROCEDURE
1. Install the mode actuator (1) to the HVAC module-auxiliary.
2. Install the screws to the mode actuator-auxiliary.
Tighten the screws to 1.9 N.m (17 lb in).