Envoy 2WD V8-5.3L VIN M (2005)
6. Remove the connector position assurance (CPA) (3) from the side impact sensor yellow 2-way connector (5) located near the middle of the door.
7. Disconnect the side impact sensor yellow 2-way connector (5) located near the middle of the door.
8. Remove the garnish molding.
9. Remove the CPA from the inflatable restraint roof rail module - left yellow 2-way inline connector.
10. Disconnect the inflatable restraint roof rail module - left yellow 2-way inline connector from the vehicle harness connector.
ENABLING PROCEDURE
1. Remove the key from the ignition.
2. Connect the inflatable restraint roof rail module - left yellow 2-way inline connector and install the CPA.
3. Install the garnish molding.
4. Connect the side impact sensor yellow 2-way connector (5) located near the middle of the door.
5. Install the CPA (3) to the side impact sensor yellow 2-way connector (5) located near the middle of the door.
6. Install the left door trim panel.