Envoy 2WD V8-5.3L VIN M (2005)
7. Remove the rear seat belt center retractor retaining nut.
8. Remove the center retractor assembly by pulling the push pin from the seat back frame.
9. Remove the seat belt retractor bracket bolt (1) from the bracket and seat back frame.
10. Remove the seat belt retractor bracket from the seat back frame.
INSTALLATION PROCEDURE
1. Position the seat belt retractor bracket on the seat back frame.
2. Install the seat belt retractor bracket bolt (1) to the bracket and seat back frame.
Tighten the seat belt retractor bracket bolt to 55 N.m (40 lb ft).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Position the seat belt retractor assembly onto the seat back frame.
4. Install the push pin on the seat back retractor to the seat back frame.
