Envoy 2WD V8-5.3L VIN M (2005)
Band Apply Servo: Service and Repair
2-4 Servo
Removal Procedure
Tools Required
^
J29714-A Servo Cover Depressor
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Support the transmission with a suitable jack.
3. Remove the transmission support.
4. Remove the front exhaust pipe assembly.
5. Remove the heat shield if equipped.
6. Carefully lower the transmission to gain access to the 2-4 Servo.
7. Install the J29714-A.
8. Tighten the bolt in order to compress the servo cover.
9. Remove the servo cover retaining ring.
10. Remove the J29714-A.
11. Remove the servo cover and the O-ring seal. If the cover is hung up on the seal, use a pick (2) to pull and stretch the seal (1) out of the groove. Cut
and remove the O-ring seal before removing the cover.