Envoy 2WD V8-5.3L VIN M (2005)
3. Connect the rear cooler lines (2) to the front cooler lines (1).
4. Install the cooling line ends (3) to the transmission. Refer to Transmission Fluid Cooler Line Quick Connect Fitting.
5. Raise the transmission into position.
6. Install the front exhaust pipe assembly.
7. Install the transmission support.
8. Remove the transmission jack.
9. Install the clip that holds the cooler lines together.
10. Install the cooler lines to the retainer (2) located on the right side of the engine.
11. Install the front sections of the cooler lines to the vehicle.
12. Install the cooler lines to the retainer located on the radiator shroud.
13. Connect the front and rear cooler lines at the quick connect fitting.
14. Install the cooler lines (4,5) to the radiator. Refer to Transmission Fluid Cooler Line Quick Connect Fitting.
15. Remove the drain pan from under the vehicle.
16. Lower the vehicle.