Envoy 2WD V8-5.3L VIN M (2005)
INSTALLATION PROCEDURE
1. Install the washer hose to the air inlet grille panel.
2. Connect the washer hose connections (1) to the washer nozzles.
3. Connect the washer hose to the clips (2) on the air inlet grille panel.
4. Install the air inlet grille panel.
5. Install the wiper arms.
Washer Hose Replacement - Liftgate
WASHER HOSE REPLACEMENT - LIFTGATE
REMOVAL PROCEDURE
1. Disconnect the rear wiper hose elbow connection (4) at the liftgate outer panel.
2. Remove the liftgate interior trim panel.
3. Remove the washer hose and grommet from the liftgate outer panel.
4. Remove the liftgate wiring harness from the liftgate.
5. Cut the rear washer hose ends where the hose ends break out of the harness and discard.
INSTALLATION PROCEDURE
1. Route the rear washer hose along the wiring harness.
2. Tape the rear washer hose to the wiring harness with 3 wraps of electrical tape at points no more than 100 mm (4 in) apart from each other.
3. Install the liftgate wiring harness to the liftgate.