Envoy 2WD V8-5.3L VIN P (2004)
3. Remove the brake hose bolt from the brake caliper assembly.
4. Remove the brake hose from the vehicle.
Important: The metal gaskets may be stuck to either the brake caliper or the brake hose end. Ensure that these gaskets are removed from the brake
hose end and the brake caliper.
5. Remove and discard the copper gaskets.
Installation Procedure
Important: DO NOT reuse the old copper gaskets. Use only NEW copper gaskets.
1. Install the NEW copper gaskets to the brake hose and bolt.
2. Install the brake hose bolt to the brake caliper.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the brake hose to brake caliper.
Tighten the brake hose bolt to 44 Nm (33 ft. lbs.).
