Envoy 4WD V6-4.3L VIN W (1998)
6.
Apply pressure on the left side of the BCM in order to move the module toward the mounting bracket base. Snap the BCM into place. Ensure that
both of the snap retainers are fully seated and holding the module.
Important:
The ignition switch should be in the OFF position when connecting the connectors to the BCM. Always connect the brown connector last.
7.
Connect the electrical connectors to the BCM.
8.
Install the center and left instrument panel sound insulators.
9.
Install the floor console on RPO YC7 (GMC Envoy) vehicles only.
Calibration Information
Important:
This calibration is not available from GMSPO. The calibration is programmed into the BCM using a Techline Tool. These calibration are available
beginning with 1998 CD ROM Disc 20 and later. Obtain the appropriate calibration by contacting Techline Customer Support Center (TCSC) at
1-800-828-B860 for a Vehicle Configuration Index (VCI). VCI's are calibration packages based on vehicle RPO content. A TCSC representative will
provide the procedure to properly program the - new BCM.
To ensure BCM programming/RPO configuration, confirm that the following conditions exist in order to prepare for BCM programming.
^
The battery should be fully charged.
^
The ignition switch should be in the RUN position.
^
The Data Link Connector (DLC) should be accessible.
Refer to the latest Techline Terminal and equipment user's instructions. Clear the Diagnostic Trouble Codes (DTCs) after the programming is complete.
Parts Information
P/N
Description
Qty
9372445
Module, Body Cont. (Except YC7)
1
9370767
Module, Body Cont. (YC7)
1
Parts are currently available from GMSPO.
Warranty Information
For vehicles repaired under warranty, use:
Labor Operation
Description
Labor Time
Computer
Use published
N4800
(Control Module),
labor
Body - Replace
operation time
ADD
Envoy
0.3 hr
