Envoy 4WD V8-5.3L (2007)
1. When replacing or repairing an emblem/nameplate do the following:
1. Use tape to protect the mounting surface during removal.
2. Use tape for alignment marks for installation of the emblem/nameplate.
2. To remove an emblem/nameplate, heat the emblem/nameplate using a heat gun. Apply heat using a circular motion for about 30 seconds.
Notice: Refer to Exterior Trim Emblem Removal Notice.
3. Use a plastic, flat-bladed tool to remove the emblem/nameplate from the panel surface.
4. When replacing, remove all adhesive as follows:
*
For body panels use a 3M(TM) Scotch Brite molding adhesive remover disk 3M(TM) P/N 07501 or equivalent.
*
For plastic panels use a lint-free cloth and Varnish Makers and Painters (VMP) naptha or a 50/50 mixture by volume of isopropyl alcohol and
water to remove the adhesive.
Installation Procedure
Important: Apply the emblem/nameplate in an environment that is free from dust or other dirt that could come into contact with the
sticky backing. Foreign material may cause improper adhesion.
1. Clean the area where the emblem/nameplate will be installed.
Use a lint-free cloth and VMP naptha or a 50/50 mixture by volume of isopropyl alcohol and water to clean the area.
2. Dry the area thoroughly.
3. Apply tape and mark the location as shown.
4. Heat the mounting surface to approximately 27 - 41°C (80 - 105°F).
5. Ensure that the temperature of the emblem/nameplate is approximately 29 - 32°C (85 - 90°F).
6. Remove the protective liner from the back of the emblem/nameplate.