Envoy 4WD V8-5.3L (2007)
4. Ensure that the hex on the rotary position sensor (2) fits in the hex of the motor/encoder housing (3).
5. Install the motor/encoder baseplate/gasket (1).
Important: When performing this service procedure, make sure that the motor/encoder unit is flat against the transfer case for proper
installation.
6. Install the motor/encoder to the transfer case.
Notice: Refer to Fastener Notice.
7. Install motor/encoder mounting bolts to the transfer case.
Tighten the bolts to 16 N.m (12 lb ft).