Envoy 4WD V8-5.3L VIN M (2005)
1. Position the fascia to the vehicle, ensuring that the body side attachment tabs are fully seated.
2. Install the 4 push-pins that retain the bottom of the fascia to the headlamp housing panel.
3. Install the push-pins (3) that retain the fascia to the fascia support rods (2).
4. Install the air defector.
5. Install the cornering lamps.
6. Install the fog lamps.
7. Lower the vehicle.
Notice: Refer to Fastener Notice in Service Precautions.
8. Install the 2 bolts that retain the top of the fascia to the headlamp housing panel.
Tighten the bolts to 10 N.m (89 lb in).
9. Install the push-pin that retains the center of the top of the fascia to the headlamp housing panel.
10. Install the grille.