Envoy 4WD V8-5.3L VIN M (2005)
18. Remove the garnish molding.
19. Remove the CPA from the inflatable restraint roof rail module - left yellow 2-way inline connector.
20. Disconnect the inflatable restraint roof rail module - left yellow 2-way inline connector from the vehicle harness connector.
ENABLING PROCEDURE
1. Remove the key from the ignition.
2. Connect the steering wheel module yellow 4-way connector (2) located left of the steering column near the knee bolster.
3. Install the CPA (1) to the steering wheel module yellow 4-way connector located left of the steering column near the knee bolster.
4. Connect the I/P module yellow 4-way connector (1) located behind the I/P support.
5. Install the CPA to the I/P module yellow 4-way connector (1) located behind the I/P support.