Envoy 4WD V8-5.3L VIN M (2005)
3. Depress the retainer (1) on the moveable roof panel control module.
4. Slide the control module towards the motor/actuator assembly to remove the module from the keyhole slots.
5. Disconnect the electrical connectors from the moveable roof panel control module.
6. Remove the module from the vehicle.
INSTALLATION PROCEDURE
1. Install the tabs located on the bottom of the control module into the keyhole slots of the moveable roof panel assembly.
2. Slide the control module away from the motor/actuator assembly, ensuring the tabs on the bottom of the control module remain in the keyhole
slots.
3. Slide the control module away from the motor/actuator assembly until the retainer (1) is fully engaged.
4. Connect the electrical connectors (2) to the control module.
5. Install the moveable roof panel actuator cover.
6. Install the moveable roof panel.
7. Perform a moveable roof panel learn cycle, by depressing the holding the roof switch in the forward position until the roof panel is fully opened,
then depressing and holding the roof switch in the rearward position until the roof panel is fully closed.
8. Ensure the proper operation of the moveable roof panel and end gate window.
Moveable Roof Panel Frame Replacement
MOVEABLE ROOF PANEL FRAME REPLACEMENT
TOOLS REQUIRED
-
Urethane Adhesive Kit GM P/N 12346392 or equivalent
-
J 39032 Stationary Glass Removal Tool
-
Cartridge-Type Caulking Gun
-
Commercial-Type Utility Knife
