Envoy 4WD V8-5.3L VIN M (2005)
3. Install the engine mount to engine.
Tighten the engine mount bolts to 50 Nm (37 ft. lbs.).
4. Install the engine mount frame bracket to the frame.
5. Install the engine mount frame bracket retaining bolts.
Tighten the bolts to 100 Nm (74 ft. lbs.).
6. Install the left side engine mount frame bracket.
7. Install the left side engine mount frame bracket retaining bolts.
Tighten the bolts to 100 Nm (74 ft. lbs.).
8. Lower the engine, aligning the engine mount studs with the holes in the frame bracket.
9. Remove the pole jack and block of wood.
10. Tighten the engine mount nuts.
Tighten the nuts to 50 Nm (37 ft. lbs.).
11. Install the shock module.
12. Install the front differential carrier.
13. Install the left side wheel drive shaft.
14. Install the engine protection shield.
