Envoy 4WD V8-5.3L VIN M (2005)
NOTE: Refer to Fastener Notice in Service Precautions.
3. Connect the electrical connector to the mode actuator-auxiliary (1).
4. Install the right rear quarter trim panel.
5. Calibrate the HVAC module actuators. Refer to Re-Calibrating Actuators (Primary) Re-Calibrating Actuators (Auxiliary HVAC) in HVAC
Systems - Automatic.
Mode Actuator - Console
MODE ACTUATOR REPLACEMENT - CONSOLE
REMOVAL PROCEDURE
1. Remove the console.
2. Remove the screw from the air outlet duct.
3. Remove the air outlet duct from the console.
4. Remove the rear mode actuator retaining screws.
5. Remove the rear mode actuator.
INSTALLATION PROCEDURE
1. Install the mode actuator.
2. Install the screws to the mode actuator.
Tighten the screws to 1.9 N.m (17 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the air outlet duct to the console.
4. Install the screw to the air outlet duct.
Tighten the screw to 1.9 N.m (17 lb in).
