Envoy 4WD V8-5.3L VIN M (2005)
9. Use the following procedure if the vehicle is equipped with 4WD:
1. Install the EVAP/fuel hose/pipe assembly to the retaining clips (1) on the transmission.
2. Raise the transmission to the normal installed height.
3. Install the transmission support.
4. Remove the transmission jack.
5. Install the transfer case.
6. Install the front propeller shaft.
10. Use the following procedure if the vehicle is equipped with 2WD:
1. Install the EVAP/fuel hose/pipe assembly to the retaining clips (1) on the transmission.
2. Raise the transmission to the normal installed height.
3. Install the transmission support.
4. Remove the transmission jack.
