Envoy 4WD V8-5.3L VIN M (2005)
5. Remove the ground terminal bolt from the engine block.
6. Remove the cable from the engine harness conduit.
INSTALLATION PROCEDURE
IMPORTANT:
-
The negative battery cable must not be connected to the battery prior to the installation of the engine harness ground terminal to the engine block.
-
The negative battery cable must not be connected to the battery prior to the installation of the instrument panel harness and the engine harness to
the powertrain control module.
1. Install the cable to the engine harness conduit.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the ground terminal bolt to the engine block.
Tighten the bolt to 50 N.m (37 lb ft).
