Envoy 4WD V8-5.3L VIN M (2005)
3. Install the rack and pinion boot (3) onto the inner tie rod assembly (2).
4. Important: The rack and pinion boot (3) must not be twisted, puckered or out of shape in any way. If the rack and pinion boot (3) is not shaped
properly, adjust the rack and pinion boot (3) by hand before installing the boot clamp.
Install the rack and pinion boot onto the gear assembly (1) until the rack and pinion boot (3) is seated in the gear assembly groove.
5. Install the boot clamp (1) on the rack and pinion boot (2) with J22610.
6. Crimp the boot clamp (1).
7. Pinch the pliers together on the rack and pinion boot (2) in order to install the tie rod end clamp.
8. Install the hex jam nut (2) to the inner tie rod assembly (1).
9. To assemble the outer tie rod assembly; refer to Rack and Pinion Outer Tie Rod End Replacement.