Envoy 4WD V8-5.3L VIN M (2005)
10. Remove the air spring level sensor-to-frame mounting bolts.
11. Remove the air spring level sensor from the vehicle.
Installation Procedure
1. Install the air spring level sensor link to the upper control arm.
Important: If not equipped, use a NEW anti-rotation bolt P/N 11569736.
2. Loosely install sensor mounting bolts with the anti-rotation bolt in the right hand mounting hole.
Notice: Refer to Fastener Notice in the Preface section.
Important: Do not remove the air spring level sensor locating pin until the air spring level sensor has been properly mounted and aligned.
3. While holding the body of the sensor, tighten the anti-rotation bolt first.
Tighten
Tighten the air spring level sensor frame mounting bolts to 8 Nm (71 lb in).