Envoy 4WD V8-5.3L VIN M (2005)
4. If replacing the passenger door module, program the passenger door module. Refer to Service Programming System (SPS) in Programming.
IMPORTANT: When replacing the passenger door module, the set up procedure must be performed.
5. Install the switch panel to the door trim panel, ensuring the front and rear retaining clips are fully seated.
Switch Replacement - Endgate Window Interior Emergency
SWITCH REPLACEMENT - ENDGATE WINDOW INTERIOR EMERGENCY
REMOVAL PROCEDURE
1. Partially remove the left rear quarter trim panel to access the switch retaining tabs located behind the panel.
2. Disconnect the electrical connector to the switch.
3. Release the tabs (1) retaining the switch to the panel.
4. Remove the switch from the vehicle.
INSTALLATION PROCEDURE