Envoy 4WD V8-5.3L VIN P (2004)
8.
Open the hood and install the prop rod.
9.
Install the left and right adjustable rubber bumpers and adjust them all the way down.
10.
Close the hood and verify adjustment. The bumpers are required to make contact with the hood. Adjust if necessary.
11.
Apply white lithium grease to the bottom of the V on the latch. Refer to illustration above.
12.
Verify the final adjustment by grabbing the hood and jiggling it up and down. If a rattle is heard, perform the procedure again.
13.
Install the grille. Refer to Grille Replacement in SI.
Warranty Information
For vehicles repaired under warranty, use the table.
Disclaimer