Envoy 4WD V8-5.3L VIN P (2004)
16.
Apply the barrier material (1) as shown. Press the material down firmly to make the harness as flat as possible. Make sure the material is securely
attached to the floorpan sheet metal.
17.
Position the jack and mounting bracket assembly to the floorpan. Check to see that the mounting bracket is not contacting the wires under the
barrier material. It is acceptable if the lower edge of the inboard mounting tab on the bracket is on top of the barrier material.
18.
Install the four 10 mm hex head nuts on the mounting studs.
Tighten
Tighten to 10 N.m (89 lb in).
19.
Install the tool package and hand tighten the retaining nut.
20.
Install the cover over the jack assembly and secure the latch.
21.
Reposition the seat to its original position.
Parts Information
NOTE:
The barrier material listed comes pre-packaged in three (3) pieces. Each piece will do two (2) vehicles. One package (3 pieces) is enough to do six
(6) vehicles.
Parts are currently available from GMSPO.
Warranty Information
For vehicles repaired under warranty, use the table.