Envoy 4WD V8-5.3L VIN P (2004)
Stabilizer Link: Service and Repair
Front
Stabilizer Shaft Link Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the stabilizer shaft link to stabilizer shaft retaining nut.
3. Remove the stabilizer shaft link to lower control arm retaining nut.
Notice: Do not pry on the stabilizer shaft link. Use care when removing or installing the stabilizer shaft link in order to avoid tearing or puncturing
the stabilizer shaft link boot. Damage to the stabilizer shaft link boot will lead to damage to the stabilizer shaft link.
4. Remove the stabilizer shaft link and washer.
Installation Procedure
Important: There is a washer between the stabilizer shaft link and the lower control arm made of hardened steel and has a felt inner liner. Only
replace this washer with an identical washer, standard washers should not be used.