Envoy 4WD V8-5.3L VIN P (2004)
2. Install the range selector cable (2) to the floor shift control assembly.
3. Install the end of the range selector cable (1) to floor control ball stud.
4. Install the drivers side front mat and carpet.
5. Install the console.
6. Raise the vehicle.
7. Install the cable to the retainer (3) on the floor panel. If the vehicle is equipped with 4WD, install the cable to the retainers located on the transfer
case.
8. Install the range selector cable (4) to the bracket (1).
9. Install the retainer (5) to the range selector cable.
10. Install the end of the range selector cable to the transmission range selector lever ball stud (6).
11. Adjust the range selector cable.
12. Lower the vehicle and check for proper operation.