Envoy 4WD V8-5.3L VIN P (2004)
2. Secure the front differential assembly.
3. Install the oil pan assembly.
4. Position the front differential on the oil pan.
Notice: Refer to Fastener Notice in Cautions and Notices.
5. Install the differential bolts.
^
Tighten the bolts to 85 Nm (63 ft. lbs.).
6. Install the inner axle shaft.
7. Position the adjustable jack stand under the lower control arm.
8. Remove the shock module from the secure position.
9. Install the right wheel drive shaft in the inner drive shaft.
10. Rinse the jack stand to allow the installation of the steering knuckle in the upper control arm. Right side shown, left similar.