Envoy 4WD V8-5.3L VIN P (2004)
1. Inspect the splines of the slip yoke for a sufficient coating of grease. If the splines of the slip yoke does not have a sufficient coating of grease,
lubricate the shaft with grease.
2. Install the propeller shaft into the transmission or transfer case.
Align the reference marks made during removal.
3. Install the propeller shaft to the rear axle pinion yoke. Align the reference marks made during removal.
Notice: Refer to Fastener Notice in Cautions and Notices.
4. Install the yoke retainers and the bolts.
^
Tighten the bolts to 20 Nm (15 ft. lbs.).
5. Lower the vehicle.