Envoy 4WD V8-5.3L VIN P (2004)
15. Disconnect the left side wheel drive shaft from the differential carrier assembly by placing a brass drift against the tripot housing. Firmly strike the
brass drift outward from the case with a hammer. Strike hard enough to overcome the snap ring pressure holding in the shaft.
16. Disconnect the right side wheel drive shaft from the clutch fork housing assembly by placing a brass drift against the tripot housing. Firmly strike
the brass drift outward from the case with a hammer. Strike hard enough to overcome the snap ring pressure holding in the shaft.
17. Pull the wheel drive shaft straight out from the differential carrier assembly or the clutch fork housing assembly.
18. Remove the wheel drive shaft.
Installation Procedure
1. Install the front wheel drive axle front differential assembly.
2. Remove the mechanics wire or hook from the front shock module/steering
3. Install the front wheel drive axle in the steering knuckle.
4. Position the shock module in the shock tower.
5. Install the shock module into the shock tower
6. Install the upper ball joint in the upper control arm.