G 1500 1/2 Ton Van V8-305 5.0L VIN H TBI (1995)
Installing Clutch Plate & Hub Assembly
4. Install the Clutch Plate and Hub Installer J 9401-B as illustrated.
5. Hold the hex portion of the Installer Body J 9401-B with a wrench and tighten the center screw to press the hub onto the shaft until there is a
0.4-0.5mm (0.015-0.020") air gap between the frictional surfaces of the Clutch Plate and clutch rotor. Check for proper positioning of the shaft
key (even or slightly above the clutch hub).
6. If operation is performed with compressor on vehicle, connect drive belt, tighten mounting brackets and adjust belt tension.
On-Vehicle
A. Position the Rotor and Bearing assembly on the front head.
Installing Rotor And Bearing Assembly (On-Vehicle)
B. With Rotor & Bearing Installer J 26271-A (without driver handle) in position and Rotor and Bearing assembly aligned with the Front Head as
shown in the illustration, drive the assembly part way onto the head.
C. Plug clutch coil connector onto Clutch Coil.
D. Position the Clutch Coil so the three (3) locating tabs will align with the holes in the head and continue to drive the Rotor and Bearing
assembly onto the front head.