G 2500 3/4 Ton Van V8-6.5L DSL Turbo VIN F (1996)
Testing For Short With Self-Powered Test Lamp Or Ohmmeter
WITH A SELF-POWERED TEST LAMP OR OHMMETER
1. Remove the blown fuse and disconnect the Battery and load.
2. Connect one lead of a self-powered test lamp or ohmmeter to the fuse terminal on the load side.
3. Connect the other lead to a known good ground.
4. Beginning near the Fuse Block, wiggle the harness from side to side. Continue this at convenient points (about 6 inches apart) while watching the
self-powered test lamp or ohmmeter.
5. When the self-powered test lamp glows, or the ohmmeter registers, there is a short to ground in the wiring near that point.
Finding Short With Short Finder
WITH A SHORT FINDER