G 2500 3/4 Ton Van V8-6.5L DSL Turbo VIN F (1996)
Fig. 5 Needle bearing removal
9.
Disassemble adjuster plug as follows:
a.
Remove retaining ring, washer, seal and bearing.
b.
Remove bearing retainer by prying at raised area, then remove seal and needle bearing with adjuster plug bearing installer tool J-8524-2 and
driver tool J-7079-2 or equivalents.
Fig. 6 Worm shaft & valve body removal
10. Remove valve and worm shaft as an assembly with both races and bearing. Separate as follows:
a. Remove worm shaft from valve body.
b. Remove races and bearing from worm shaft, them remove seal.
Fig. 7 Stub shaft pin disengage
11. Remove stub shaft from valve body as follows:
a. Hold assembly and lightly tap stub shaft against a bench until shaft cap is free from valve body.
b. Pull shaft assembly until shaft cap clears valve body by approximately 1/4 inch.
c. Remove valve spool and seals.
12. Remove screws, clamp and ball guide from rack piston, then remove balls.
13. Remove connectors from housing.