G 2500 3/4 Ton Van V8-6.5L DSL Turbo VIN F (1996)
Fluid Line/Hose: Service and Repair
TRANSMISSION OIL COOLER LINE REPLACEMENT
REMOVE OR DISCONNECT
1. Bolt securing the clip and cooler lines to the engine.
2. Remove the two cooler lines from the two quick connect fitting on the transmission or the auxiliary oil cooler by using the following procedure:
-
Remove the plastic cap from the connector by pulling back along the pipe (about 2 inches).
-
Using a bent tip screwdriver, pull on one of the open ends of the retaining ring clip.
