G 3500 1 Ton Van V8-379 6.2L DSL VIN J FI (1992)
J 24092 Pulley Hub Adapter Set
1. Clutch plate and hub assembly (2).
Removing The Pulley Retainer Ring
2. Pulley bearing retainer (2) with J 6435.
3. Pulley (6).
Removing The Pulley And Bearing
^
Install J 9395 over the end of the compressor shaft (38).
Important
^
Use J 9395 puller pilot to prevent internal damage to the compressor when removing the pulley. Do not use the pulley directly against the
end of the shaft.
^
Place J 8433 over J 9395 for the regular V-groove pulley.
^
Place J 24092 over J 9395 for the multi-groove pulley.
^
Turn the screw on J 8433 to remove the pulley (6).
Important
^
When using J 24092, the puller arms must extend around to the rear side of the pulley. Do not attempt to pull the pulley off by engaging the
puller arms in a multi-groove pulley.