gmc Workshop Repair Guides

GMC Workshop Service and Repair Manuals

Campaign - A/T, Incorrect Dipstick Installed|Page 2984 > < A/T - New Fluid Level Indicators & Fluid Check Procedure|Page 2979
Page 1
background image

Technical Service Bulletin # RECALL92C08

Date: 920401

Campaign - A/T, Incorrect Dipstick Installed

IMPORTANT

GMC TRUCK RECALL NOTICE

CAMPAIGN 92C08

PLEASE RETAIN THIS COPY FOR YOUR FILE. YELLOW CAMPAIGN BULLETIN WILL NOT BE SENT FOR THIS CAMPAIGN.

THE FOLLOWING WAS SENT VIA DCS/EMS ON APRIL 1, 1992.

NUMBER: 92C08  
                                            
DATE: APRIL 1992

GROUP: 7A - AUTOMATIC TRANSMISSION

SUBJECT: INCORRECT DIPSTICK INSTALLED

MODELS: 1992 G3 VANS

THIS MESSAGE IS BEING SENT TO INVOLVED DEALERS ONLY.

General Motors has determined that certain 1992 G3 vans equipped with 4L80-E automatic transmissions (RPO MT1) were shipped from the
Scarborough assembly plant with the incorrect blade on the transmission fluid level indicators (dipsticks). The full cold indicator on the incorrect
dipstick is 18.9 mm. (3/4 in.) higher than on the correct dipstick. The transmission fluid was at the correct level when the vehicles were shipped from the
plant. However, if someone were to check the fluid level with the incorrect dipstick, the fluid would appear to below. Approximately 39 oz. of fluid
would be required to bring the reading on the dipstick up to the full cold mark. If this much additional fluid were to be added to the transmission, the
transmission's performance and durability could be affected.

To prevent these conditions from occurring, the correct transmission dipstick will be installed.

Vehicles Involved

Campaign - A/T, Incorrect Dipstick Installed|Page 2984 > < A/T - New Fluid Level Indicators & Fluid Check Procedure|Page 2979