G 3500 1 Ton Van V8-454 7.4L VIN N TBI (1995)
Removing Shaft Seal
6. Fully engage the knurled tangs of seal remover-installer J 23128-A into the recessed portion of the seal by turning the handle clockwise. Remove
the seal from the compressor with a rotary-pulling motion. Discard the seal. The handle should be hand-tightened securely. Do not use a wrench or
pliers.
Removing Shaft Seal O-Ring
7. Remove and discard the seal O-ring from the compressor neck using O-ring remover J 9553-01.
8. Recheck the shaft and inside of the compressor neck for dirt or foreign material and be sure these areas are perfectly clean before installing new
parts.
Clean
^
Thoroughly clean seal O-ring groove in front head.